Product introduction
The BJ8M608B is a single chip 8-bit MCU based on RISC architecture with built-in 2K× 16-bit MTP program memory. It is manufactured using an advanced CMOS process with low power consumption characteristics and low operating voltage capability. The chip integrates three timer modules, which can provide timing, counting and PWM functions. Internal watchdog, low voltage reset, low voltage detection functions ensure the reliable operation of the system. In addition, the MCU includes rich IO resources and can be widely used in various products.
Application field
Consumer electronics, small appliances, etc.
CPU characteristics
RISC architecture, 1T kernel.
5 layers of hardware stack.
Store
Program memory: 2K x 16bits.
Data RAM: 96 x 8bits.
EEPROM: 128byte.
Instruction set
68 instructions.
Interrupt
Unique interrupt entry address (08h).
Supports IO flip interrupts (14 IO supports).
Supports internal interrupts: T0, T1, T2, LVD.
I/O port
Bi-direction IO port: 14.
Pull-up resistance port: 14.
Pull-down resistance port: 14.
Open drain port: 14.
Wake up port: 14.
IO flip interrupts port: 14.
I/O port source current/sink current: 20mA.
7 high drivers, with 4 level 20mA,40mA,60mA,80mA.
Timer/counter
Timer/counter 0
8-bit basic timer/counter.Supports the pre-division function.
Timer/counter 1
Automatic loading of 16-bit timer/counter.
4 PWM output.
Supports the pre-division function.
Timer/counter 2
Automatic loading of 16-bit timer/counter.
3 PWM output.
Supports the pre-division function.
Watchdog timer
Supports the pre-division function.
Can configure overflow reset or wake up.
Clock system
Internal RC oscillator (master clock)
Frequency: 1MHz, 2MHz, 8MHz, 16MHz, error: ±1%.
Internal RC oscillator (WDT clock)
Frequency: 128KHz, error: ±3%.
Can work with dual clocks
Oscillator can be divided frequency: 1, 2, 4, 8.
Working mode
Common mode: Both high-speed and low-speed clocks work properly.
Low-speed mode: Only the low-speed clock works properly.
STOP mode: All clocks stop working.
IDLE mode: The CPU stops working and peripherals can work.
Low voltage reset (LVR)
Low voltage reset options: 1.9V, 2.2V, 2.8V, 3.4V.
Low Voltage Detection (LVD)
Low voltage detection options: 2.0V, 2.4V, 3.0V, 3.6V.
Can be configured to generate interrupts.
Low power mode
STOP mode:0.7uA @3.0V.
STOP mode:0.9uA @5.0V.
Operating temperature range
-40℃ ~ +85℃.
Voltage operating range
1.8V~5.5V.
Anti-interference capability
ESD: Better than ±4000V.
EFT: better than ±4000V.
Pin assignment diagram
Copyright © Foshan Angke Electronic Technology Co., Ltd All rights reserved 粤ICP备2023051041号